aboutsummaryrefslogblamecommitdiffstats
path: root/doc/check-health.md
blob: 8e271d6c3303c321547f5d788c1c67756be23554 (plain) (tree)
1
2
3
4
5
6
7
8



                                          

                                                                               




                                                                       
                                                                              








                                                                


                        
                                                                                

                
                                                                                   

              
                                                                           
 









                                                                                                                         
                                                                            
                                                                                  
                                                                       
                                                                        
                                                                           


                                            
Notify about health state
=========================

[◀ Go back to main README](../README.md)

🛈 This script can not be used on its own but requires the base installation.
See [main README](../README.md) for details.

Description
-----------

This script is run from scheduler periodically, sending notification on
health related events:

* voltage jumps up or down more than configured threshold or drops below limit
* power supply failed or recovered
* temperature is above or below threshold

Note that bad initial state will not trigger an event.

Only sensors available in hardware can be checked. See what your
hardware supports:

    / system health print;

### Sample notifications

#### Voltage

![check-health notification voltage](check-health.d/notification-01-voltage.svg)

#### Temperature

![check-health notification](check-health.d/notification-02-temperature-high.svg)  
![check-health notification](check-health.d/notification-03-temperature-ok.svg)

#### PSU state

![check-health notification](check-health.d/notification-04-psu-fail.svg)  
![check-health notification](check-health.d/notification-05-psu-ok.svg)

Requirements and installation
-----------------------------

Just install the script and create a scheduler:

    $ScriptInstallUpdate check-health;
    / system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;

Configuration
-------------

The configuration goes to `global-config-overlay`, these are the parameters:

* `CheckHealthTemperature`: an array specifying temperature thresholds for sensors
* `CheckHealthVoltageLow`: value (in volt*10) giving a hard lower limit
* `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps

Also notification settings are required for e-mail, matrix and/or telegram.

---
[◀ Go back to main README](../README.md)  
[▲ Go back to top](#top)