blob: de7f9eb1283ff99de2028235f30620f587626daa (
about) (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
|
Notify about health state
=========================
[◀ Go back to main README](../README.md)
🛈 This script can not be used on its own but requires the base installation.
See [main README](../README.md) for details.
Description
-----------
This script is run from scheduler periodically, sending notification on
health related events:
* voltage jumps up or down more than configured threshold
* power supply failed or recovered
* temperature is above or below threshold
Note that bad initial state will not trigger an event.
Only sensors available in hardware can be checked. See what your
hardware supports:
/ system health print;
Requirements and installation
-----------------------------
Just install the script and create a scheduler:
$ScriptInstallUpdate check-health;
/ system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;
Configuration
-------------
The configuration goes to `global-config-overlay`, These are the parameters:
* `CheckHealthTemperature`: an array specifying temperature thresholds for sensors
* `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps
Also notification settings are required for e-mail, matrix and/or telegram.
---
[◀ Go back to main README](../README.md)
[▲ Go back to top](#top)
|